Built-ins, columns, wine, drawers, ice
Line answered 24/7

Beverly HillsSub-Zero Specialists
Call (310) 706-2347
Menu

Journal · Local & Seasonal

Moving Day for Your Refrigerators: Before, During, After

Refrigeration is the one part of a move that cannot simply be boxed and unboxed. A Sub-Zero you bring with you needs careful handling and a rest before it runs, and a Sub-Zero you inherited with the property needs a proper look before you trust it with a week of groceries. This article walks through each situation.

Direct reply 1/3

How do you move a Sub-Zero refrigerator?

Freestanding units can be moved by careful movers: empty, defrost and dry them, secure the doors, and keep them upright on a dolly. Built-in Sub-Zero models are anchored, plumbed and very heavy, so they should be pulled out, disconnected and reinstalled by professionals who work from the installation guide. Never lay a refrigerator flat if you can avoid it.

A refrigerator's moving day, stage by stage

These are the stages, not a schedule. Their length varies with the unit, the distance and the house at the other end.

  1. Before the truck

    Use up or give away perishables, then empty every shelf, bin and drawer. Remove loose glass shelves and pack them separately so they do not shatter in transit.

  2. Shut down

    Power the unit down from its control panel or at the breaker. On models with an ice maker, turn off the water at the shutoff valve and empty the ice bin.

  3. Defrost and dry

    Prop the doors wide, lay towels on the floor below, and wait until any frost has melted, then wipe the interior dry. Water left inside can spill into insulation or freeze again in a cold truck.

  4. Secure and protect

    Tape the doors shut with painter's tape or a strap that will not leave residue, and wrap the cabinet in moving blankets. Keep the power cord and water line coiled and fastened to the back.

  5. Transport upright

    Keep the refrigerator standing on a proper appliance dolly and in the truck. Tilting it for a doorway is fine; laying it down for the ride is what to avoid, because oil from the compressor can drift into the refrigerant lines.

  6. Settle before power

    Once it stands in its new place, let it rest upright before plugging it in, so any oil that moved can drain back to the compressor. A unit that was laid down needs a longer rest.

  7. First run

    Switch it on empty, check that the display and fans come alive, and give it time to get fully cold before any food goes in. Reconnect and flush the water line before trusting the ice.

Moving myths that cost owners a compressor

  • Often heardA refrigerator can travel on its back like any other box.

    In practiceLying flat lets compressor oil migrate into lines where it does not belong. Upright transport is the rule. If it truly had to lie down, a much longer rest before startup gives the oil time to return.

  • Often heardPlug it in right away so it gets cold sooner.

    In practiceStarting immediately after a rough move can pump oil around the system before it settles. A rest first is cheap; a damaged compressor is not.

  • Often heardIf it runs, it survived the move.

    In practiceRunning and cooling are different things. Watch it reach and hold its setting over a full day before restocking, and listen for new rattles from a shifted fan or loose panel.

  • Often heardA built-in can be slid out like a freestanding model.

    In practiceBuilt-ins are fastened to the cabinetry with anti-tip brackets, connected to water and often fitted with custom panels. Forcing one out damages floors, panels and the unit itself.

Direct reply 2/3

How long should a refrigerator stand before turning it on after a move?

If it stayed upright the whole way, a short rest is usually enough; let it stand while you unpack the rest of the kitchen. If it was tipped or laid on its side, a common rule is to let it stand upright at least as long as it was down, up to a full day. Follow the installation guide when it gives a figure.

What is different about moving in Beverly Hills

Getting a large refrigerator into a house is mostly about the route. In the hills above Sunset, steep driveways and winding streets can make it hard for a full-size truck to get close, and the last stretch may happen on a dolly up a slope. In the Flats the streets are wider, but older homes can have narrow doorways, tight turns into the kitchen and floors that need protection. Measure the doors and the path before moving day, not on it.

Many houses here already come with a full set of Sub-Zero refrigeration: a main built-in, perhaps a wine unit in a bar or cellar, undercounter drawers in a pantry or by the pool. Buyers often inherit equipment with an unknown history. Sellers sometimes switch units off while a house stands empty, and a refrigerator left closed and powered down for weeks can grow mold and odors that need careful cleaning.

Checking the refrigeration in your new house

Walk through this list in the first days, before the kitchen is full and the units are hard to reach.

  • Photograph the rating plate with the model and serial numbers inside each unit; any technician will want those numbers first
  • Stand a thermometer in a small jar of water inside each unit until morning, then see whether it agrees with the display
  • Shut a dollar bill in each door at the corners and sides; anywhere it slips out freely, the gasket is letting warm air in
  • Shine a flashlight through the grille onto the condenser; a heavy gray coat means nobody has cleaned it for a long while
  • Locate the water shutoff for every unit with ice or water, and check the supply lines for drips
  • Ask the sellers about the last filter change or look for a date on the cartridge; if nobody can say, put in a new one
  • Throw away the first batches of ice and run water through the dispenser before using either
  • Open each wine unit and check that temperature and humidity hold steady and the glass does not fog
  • Listen to each unit for a while: clicking, grinding or constant running are worth noting before you call
  • Smell the interiors; a musty odor in a unit that was switched off with the doors closed needs cleaning before food goes in

Built-in units are a professional lift

Direct reply 3/3

What should I check on appliances when I move into a new house?

For refrigeration, check that each unit reaches and holds temperature, that every door seals, that the condenser is reasonably clean and that water lines and shutoffs are dry and easy to reach. Record the model and serial numbers, change the water filter if its age is unknown, and discard the first ice before using it.

Settling in after the move

Questions people ask when they move

Can you inspect every Sub-Zero unit in a home we have just purchased?
Yes. The visit costs $89, a single charge no matter how many Sub-Zero units are inspected that day, and it is applied to a repair if one is needed. Repair pricing is quoted once the diagnosis is done, and nothing proceeds without your approval. Our built-in refrigerator page explains what the technician looks at.
The previous owners left the refrigerator off and it smells. Is it ruined?
Usually not. Most odors come from mold on interior surfaces and gaskets and clean out with mild soap and water and a good airing with the doors open. If the odor comes back after the unit has been cooling for a while, the drain or the area behind interior panels may need a technician.
My Sub-Zero made a loud noise after the move and now cools poorly. What happened?
Something may have shifted in transit, such as a fan rubbing on its housing, a loose panel or a line rubbing against the cabinet. Poor cooling after a move can also mean the unit was started too soon. Switch it off and call for a diagnosis rather than letting it run.
How do I reach you once we have moved in?
Call (310) 706-2347, answered 24/7, or use the online booking. Our contact page has both, and more moving and seasonal articles are in the journal.

New house, unknown refrigerators?

Have every Sub-Zero unit checked on one visit. Call (310) 706-2347 or book online; visits run 8 AM–6 PM, Monday through Sunday, and the $89 fee counts toward any repair.

$89 buys the visit, never a per-unit tally; approve the fix and those $89 are deducted from its invoice.