Built-ins, columns, wine, drawers, ice
Line answered 24/7

Beverly HillsSub-Zero Specialists
Call (310) 706-2347
Menu

Drawers · Undercounter

Sub-Zero drawer and undercounter repair, down at knee height

Refrigerator drawers do their job in the hardest spot in the kitchen: by the floor, next to the dishwasher, kicked shut and loaded heavy. When a Sub-Zero drawer runs warm, frosts up or stops gliding home, we trace it through the rails, the sensor and the sealed system — one $89 trip fee whether we open one drawer or five.

4.8 / 5 · 187 ratings About these reviews

Direct reply 1/3

What does Sub-Zero refrigerator drawer repair involve?

A technician works through three areas in order: the rails and drawer front that press the gasket shut, the temperature sensor and control that decide when to cool, and the compressor and condenser that make the cold. Nearly every drawer fault lives in one of them. The trip costs $89; it disappears into the repair total once you approve, and the repair gets a price only after the faulty part is identified.

Three kinds of cold under the counter

Sub-Zero builds compact refrigeration in a few shapes. They share the same cramped installation, yet each one breaks down a little differently. Undercounter wine units have a page of their own: wine storage repair.

Sub-Zero undercounter formats side by side

FormatWhere it usually livesWhat tends to go wrong
Refrigerator drawersKitchen islands, prep zones, beside a secondary sinkRails that sag under heavy loads, a worn seal letting air past, one drawer running warmer than the other
Freezer drawers, or a refrigerator-and-freezer pairNext to a refrigerator drawer, in a pantry or a second kitchenFrost on the drawer walls, a fan blade iced in, a drawer that sticks after it was left open
Undercounter refrigerator with a hinged doorBars, butler's pantries, media rooms, outdoor living spacesA door hinge out of adjustment, a blocked front grille, heat soaking in from a neighboring appliance

Direct reply 2/3

My Sub-Zero undercounter fridge isn't cooling — what's wrong?

Look at the toe kick first. Undercounter Sub-Zero units breathe through that low front grille in both directions, so a rug, a pair of shoes or a layer of lint can starve the condenser. With the grille clean, look next at a door seal gone flat, a dead fan motor, a thermistor giving false readings, or a compressor stuck at the start.

A pale oak island with Sub-Zero refrigerator drawers, the lower drawer pulled fully out with limes, herbs and glass jars in clear bins, held by chartreuse-gloved hands, breeze-block sunlight on the concrete floor

What a failing drawer does

Drawers give away their faults in fairly specific ways. Pair the sign in your kitchen with its likely source, and the phone call goes quicker.

  1. The drawer stops an inch short or bounces back open

    Likely A bent or dirty rail, a broken drawer stop, or something wedged behind the bin is holding the front off the gasket

  2. The top drawer is cold and the bottom one is not

    Likely On combination units each drawer is controlled separately, so one sensor, one fan or one iced-over air passage can fail while the other drawer carries on

  3. Frost on the drawer walls or a crust of ice on the food

    Likely Humid kitchen air sneaks in around a split or crushed seal, or a tired rail is leaving the drawer slightly ajar

  4. A click from the base, then silence, and the drawers slowly warm

    Likely The compressor attempts to kick on and gives up — sometimes a start relay, sometimes the compressor itself, often made worse by a choked condenser

    Repair page
  5. The unit runs nonstop and the cabinet beside it feels warm

    Likely Warm exhaust air is trapped: a blocked toe-kick grille, or a dishwasher or oven next door adding heat to the cabinet

  6. Water collecting under the drawer bin

    Likely The defrost drain is plugged by crumbs or a plug of ice, so melt water sits in the drawer instead of reaching the pan

Our order of work on a drawer

Drawer faults have three usual homes — the rails, the temperature sensing and the sealed system. We check them in that order, because it runs from the simplest fix to the most involved.

  1. Watch it close

    Before any tool comes out, each drawer is opened and shut loaded the way you use it. A drawer that seals empty but not full points to the rails; one that never seals points to the gasket or a drawer front that has shifted.

  2. Take the drawer out and read the rails

    Most Sub-Zero drawers lift out of the cabinet so the slides can be inspected. We look for bent tracks, worn rollers, broken stops and debris, and check that the front sits square to the cabinet opening.

  3. Check the sensor against our own thermometer

    A reference thermometer goes into each drawer and its reading is compared with what the control believes. If the two disagree, the trouble is in the sensing, not in the cooling.

  4. Test the sealed system

    If the readings agree and the drawer is still warm, we listen to the compressor start, check the condenser fan and coil, and read the frost pattern on the evaporator — it tells us whether defrost or the refrigerant side is to blame.

  5. Explain, price, then repair

    We name the failed part and quote the job before a screw turns; yes or no is up to you. Say yes and the $89 trip fee comes off the bill.

Repair or replace the whole drawer unit?

  • Often heardRefrigerator drawers can't really be fixed — once they fail, the whole unit gets swapped out.

    In practiceRails, gaskets, sensors, fans, controls and start components are separate parts, and any one of them can be swapped alone. Is it worth fixing? That hinges on which part let go and how sound the remaining unit looks — an answer that only comes after diagnosis, with a quote in hand.

  • Often heardIf the drawer lights up and hums, it must be cooling.

    In practiceLight and fan noise only prove the unit has power. A drawer can hum all day while the food inside sits well above the 36–38°F a refrigerator should hold; an inexpensive thermometer in the drawer tells you more than the sound does.

Direct reply 3/3

How do refrigerator drawers stay cold?

A small sealed system — compressor, condenser and evaporator — sits in the base of the unit. A fan moves chilled air through the drawers, a sensor tells the control when to run, and the drawer gasket, pressed shut by the rails, keeps the cold in. On Sub-Zero combination models the two drawers can be set to different temperatures.

Drawer repair across our twelve neighborhoods

The drawer mechanics never change; the homes holding them vary a lot. Each page below looks at drawers and undercounter units in one part of our area.

  • Local service

    Beverly Hills

    Island drawers in the Flats and in hillside Trousdale Estates kitchens.

  • Local service

    Bel Air

    Gated hillside houses — mention the gate code or entry route when you book.

  • Local service

    Holmby Hills

    Large estates with drawers in more than one kitchen, bar or pantry.

  • Local service

    Century City

    High-rise condominiums, where building rules and elevators shape the visit.

  • Local service

    West Hollywood

    Compact apartment and loft kitchens where drawers carry a lot of the load.

  • Local service

    Westwood

    Wilshire Corridor condos and the houses in the hills above them.

  • Local service

    Brentwood

    Family kitchens where snack and drink drawers open all day long.

  • Local service

    Hancock Park

    1920s houses with remodeled kitchens built inside original rooms.

  • Local service

    Los Angeles

    Other Los Angeles addresses in our area — call to confirm your street.

  • Local service

    Santa Monica

    Homes near the ocean, where salt air works on coils and slides.

  • Local service

    Pacific Palisades

    Kitchens rebuilt since the Palisades fire, often with brand-new drawers.

  • Local service

    Culver City

    Updated kitchens and home bars across the residential neighborhoods.

  • Pricing

    How the visit is priced

    Why the trip fee is $89 flat and how repair quotes are worked out.

Drawer questions from owners

Will one visit cover my refrigerator drawers and my built-in refrigerator too?
Yes. $89 buys the trip itself, so drawers, the built-in refrigerator and a wine column can all be examined during one stop. Every fix gets its own quote once diagnosed, and you pick which to approve.
Should I empty the drawers before the technician gets here?
It helps. Move the food to the main refrigerator or a cooler and leave the drawers empty, so they can be lifted out and the rails inspected. Keep the unit running unless it is leaking or tripping a breaker — a running unit shows us far more than one that has been switched off.
Do drawers built into an island need different care?
Mostly they need air and a clear toe kick. Keep mats, stools and shoes off the grille, don't use an open drawer as a step, and clean the condenser on the schedule Sub-Zero recommends. If you are planning an island around drawers, our note on kitchen design covers the basics.

Drawer warm, sticking or frosted over?

Phones are answered 24/7. Technician hours: 8 AM–6 PM, Monday through Sunday — and if today's route has an opening, it can be today. Book online or call and describe what the drawer is doing.

$89 buys the visit, never a per-unit tally; approve the fix and those $89 are deducted from its invoice.